Driveshaft Balancing Machines

At CIMAT, we produce and supply special balancers for drive shafts. Our special drive shaft balancers are well-equipped and have the latest software capabilities, even in the most basic models—balancing in four correction planes at the same time is a standard feature.

Get a Quote

Details
Details
Technical Specifications

Our advanced measuring unit, the ROTORTEST 9.5, is equipped with an LCD touch screen that displays balancing results and utilizes the latest software, making operation easier than ever before. You can even save data on external storage via a USB port, send it via wifi or ethernet, or print the balancing reports out with a built-in laser printer.

Advantages

  • Ability to balance in four correction planes at the same time
  • Accurate and efficient
  • Intuitive and easy to operate software
  • Reinforced external pedestals designed to withstand high axial loads on the splined connector
  • The middle pedestals of the machine are specially designed to accept  the support bearings of a drive shaft, without disassembly
  • The right pedestal can move horizontally on the bed while the upper part of the right pedestal can move in 50mm steps—this is designed to connect the shaft's disc to the pedestal's disc
  • Balancing speeds up to 5000 rpm
  • Protective mechanisms that prevent the drive shaft from falling out of the machine
  • Angle indexing display in switch-off mode
  • Balancing reports are saved in database for later use
  • Software converts correction mass into exact length of the correction strips
  • Servo motors programmed to position drive shaft for correction
  • Automatic positioning of pedestals
  • Pneumatic system for the automatic installation of the drive shaft in the spindle, blocking the right pedestal, closing and opening the protective mechanism preventing the drive shaft from falling out from the machine, and opening and closing the safety cover
  • Automatic or manual welders

The following parameters are standard and can be modified upon request.

Model CMT-250WN
Tool orientation Horizontal
Positional control Servo
Maximum component weight 250 kg
Maximum rotor height 4600 mm
Maximum correction radius 170 mm
ISO 2953 Reduction Ratio 98%
Drive motor TBD
Voltage & phase 380-480v 3 phase